How to Hook Up a Water Line to a Refrigerator From the Sink
In this kitchen, we ran the new refrigerator water line from under the kitchen sink through cabinets. We removed the drainpipes to clearly show this project. Be sure to keep the design dating website above storage areas and behind drawers if possible waterline avoid tube damage.
If you need to drill through floors or walls, check for air ducts, electrical wiring, plumbing or other onlinedating delhi impediments first. Figure 6 to 8 ft. Then decide which one of three refrigerator water line connection options you will use: If you have CPVC plastic or steel pipes, add tee fittings made of the same material.
Add pipe compound to the threads to make it easier to tighten compression joints. It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce refrigerator outer wall of the pipe when screwed inward.
Then you back out the rod and water hook through a tiny hole into the tubing. To begin, shut off the water at the main valve, then open the sink faucet and another lower level faucet to drain the pipe. Next, cut out a hook section of hook cold waterline pipe and solder in a copper tee. Cut a 3- to 4-in. Once the assembly has cooled, close the new valve and open the hook up watch main to check the fittings for leaks. To straighten coiled tubing not the entire rollhave a partner refrigerator the end of the tube flat on the floor, then push the roll waterline the floor while unrolling to the length you need to go through the cabinets.
Now snake the tubing in backward, starting at the refrigerator so the coiled portion remains there. Then attach the tubing to the back of the cabinets every 2 to 4 ft. Wrap the female thread on the opposite end of the adapter with thread-seal tape.
How to Install the Water Line For The Four Door Refrigerator
Twist the faucet supply line onto dating a lawyer tips female hook of the adapter. Slip the compression nut that came with the kit over the newly installed supply line. Make sure the waterline are facing the end of the line. Hook the ferrule from the kit onto the new line. Wrap the remaining male threads on the quick-tee adapter with thread-seal tape.
Insert the new water line into the opening on the tee. Slide the compression nut over the male threads and tighten it on the adapter. Tighten all three nuts on the quick-tee refrigerator with pliers or an adjustable wrench. Do not twist the nuts too tight as refrigerator could damage the supply valve, the supply line waterline the adapter. Place the end of the water line you intend to connect to the refrigerator into a 5-gallon bucket.
Turn the cold water supply valve on beneath the sink.
Let 1 or 2 gallons of water run through the new line to remove the air. Turn off the supply line. Slip the refrigeratpr compression nut and ferrule refrigerator the refrigerator end of the new water waterline.
Connect the line to the water line connector on the back of the refrigerator. Hook the supply line hookup site 2014 once again. Watch for leaks at all the connections.
The Best Line Tubing to Use to Hook Water up to a Refrigerator | Dengarden
Tighten the connections slightly yp you see a leak. If tightening the connection does not stop the leak, turn off the water, waterline the connector and add additional thread-seal tape before reconnecting the water line. Plug your refrigerator into the wall. Coil the excess water line behind the refrigerator. Push the refrigerator refrigerator the wall. Cecilia Harsch has hook writing professionally since She writes mainly home improvement, health and travel articles for various online publications.